How to change the node name of a Juniper SA?

[timpremereur_]

Hi,

Does anybody know how to change the node name of a Juniper SA? Our platform runs software version 7.0R2

Kind regards,

Tim

[firewall72_]

Hi Tim,

Go to System, Network, Overview and change the Hostname field. Save the config, then check the Maintenance, System page to verify the change was applied. I hope this helps.

[timpremereur_]

Hi John,

The solution you propose allows to change the hostname of the cluster, though I'm searching for a way to change the names of the nodes within the cluster.

Kind regards,

Tim

[MattS_]

The Hostname field in the Network Identity section of System > Network > Overview is the aplliances fully-qualified hostname.

The cluster configuration is under System > Clustering

[srigelsford_]

Changing the node names within the cluster (as they appear in the clustering page, rather than the hostnames which are already covered in this thread) can only be done by recreating the cluster.

Sam.

JNCIS-SSL JNCIS-FWV JNCIS-SEC JNCIS-ER

[timpremereur_]

Thanks a lot! :-)