I didn't see this mentioned in the supported OS doc. Can I use the 9.x clients? Would like the built-in browser for SAML auth and RS4 support.
You can use the 9.x client with 8.3, however, you'll need PCS 9.0 to turn on the ability to use the embedded browser for SAML.
Here's the config snippet:
This is the Connection Set client behavior part of the PCS config. You may be able to do it using a preconfig file, but you'd still need PCS 9.0 to generate the preconfig file.
Is there any chart showing version’s compatibility between Clients and PCS?
I’ve looked for such information in the documentation but without any results.
We are using PSA-5k with the 8.3R5.1 firmware and we are preparing for upgrade to the 9.0R2.1 version. The initial tests of 9.0R2.1 Client with our PSA-5k are unsuccessful, so at this point we don’t know if this is a specific notebook/OS issue or a general incompatibility.
The best upgrade scenario for us is to upgrade as many Clients as possible in the first step, and then the PSA-5k in the second one.
TIA and best regards,
Exactly what I would like to know also...
(in my case: can't place 9.0 on a MAG2600, but the download site suggests it can...)
Error on upgrade attempt: "Step 5: This hardware platform is not supported by software version 9.0R2.1 Build 63975 ... complete (0 seconds)"
In the Relese Notes for 9.0R2.1 there is a section about supported platforms:
You can install and use this software version on the following hardware platforms:
• PSA300, PSA3000, PSA5000, PSA7000F, PSA7000C
Unfortunately, there is no MAG2600.