cancel
Showing results for 
Search instead for 
Did you mean: 

cannot import xml config file into mag2600, error message

New Contributor

cannot import xml config file into mag2600, error message

we have a MAG2600 we use solely as a web proxy. it ran on firmware 8.3R2

its harddrive just failed, but thankfully we have a back up of the config xml file.

so I replaced the harddrive and factory reset then upgraded it to 8.3R2 (same f/w the xml file was backed up from).

i am trying to import the xml file but i am getting an error message...

Fatal error in XML file at line: 464, column: 72 Message: Entity 'Atilde' was not found Framework: Encountered a validation error in the XML file Failure..

 

i have tried deleteing the lines that contain the "atilde" but more errors pop up.

 

i can read the xml file, but i dont understand how to pull the necessary parameters to use to manually configure the web proxy since the import xml doesnt work.

is there a way i can at the pull the settings parameters necessary to manually configure the web proxy by just looking at the xml file?

any suggestions will be appreciated.

 

thanks

 

1 REPLY 1
Highlighted
Moderator

Re: cannot import xml config file into mag2600, error message

Check the section for proxy settings
Do you have the user.cfg & system.cfg (please note, these are required for full backup) files that you can import?