cancel
Showing results for 
Search instead for 
Did you mean: 

Adding multiple entries for VPN traffci in Juniper SSG20 route based VPN

Highlighted
Occasional Contributor

Adding multiple entries for VPN traffci in Juniper SSG20 route based VPN

We are trying to configure site to site VPN between cisco and juniper SSG20 device, the cisco side has two LAN networks, but we are not able to add both of them to the VPN traffic on the juniper side:

The SSG20 allows us only to add one network entry as an VPN traffic to be encrypted.

Bur How shall we make other remote network accessible over VPN.?

Please help? This is urgent issue

2 REPLIES 2
Highlighted
Frequent Contributor

Re: Adding multiple entries for VPN traffci in Juniper SSG20 route based VPN

Hi,

I would try a single IKE Gateway and two (2) AutoKey IKE (or VPN) entries. The VPN's will be used for the SA and should match the Cisco ACL on the other end. Are you setting up Policy or Route based VPN?

John

Highlighted
Occasional Contributor

Re: Adding multiple entries for VPN traffci in Juniper SSG20 route based VPN

Adding a single IKE gateway gives error when doing it for the second remote LAN?

It is route-based VPN