Return Attribute juniper-firewall-filter-name

[RadiusAttributes]

On uac i configure both add vlan attribute and Return Attribute juniper-firewall-filter-name apple .Switch sucessfully put the port

correct vlan but not apply firewall filter which i was defined on uac.

By the way uac said successfully applied radius attributes. (mac authentication)[xxxx] - User assigned RADIUS attribute(s) (Juniper-Firewall-filter-name='apple')

What is the problem or Are there any one add return attribute juniper-firewall-filter-name...

[CraigB_]

What happens if you just return the filter name and omit the VLAN?

Does the attribute make it.

I am in the UAC support team and I think there was an issue reported on the EX product where it would only accept one attribute.

If your test shows that when the VLAN is omitted and the filter is applied, then I suggest you open a JTAC case and see if this was addressed or is a known issue.

Good luck

Craig