cancel
Showing results for 
Search instead for 
Did you mean: 

could not redirect https site enforcer config with nac-srx

SOLVED
RadiusAttributes
Contributor

could not redirect https site enforcer config with nac-srx

hi everyone ;

i could not find any documentation about redirect web page is  support only  http traffic.

i have configured our srx devices like below  and  can redirect http sites to our captive portal but i could not redirect 

https site , for example user try to join  https site --https:\\facebook.com no redirect page display.

what can be the problem or are there any limitations about https sites

Thanks

 

 

 

 

unified-access-control {     captive-portal acs-device {         redirect-traffic unauthenticated;         redirect-url https://%ic-ip%/?target=%dest-url%&enforcer=%enforcer-id% ... 
[email protected]show security policies
... from-zone trust to-zone untrust {     policy  redirect {         match {             source-address any;             destination-address any;             application any;                       }         then {             permit {                 application-services {                     uac-policy {                         captive-portal acs-device;                     }                 }             }         }     }
1 ACCEPTED SOLUTION

Accepted Solutions
apaul_
Regular Contributor

Re: could not redirect https site enforcer config with nac-srx

Hello,

 

Captive portal only works on port 80 with HTTP.

Its documented in the Junos Pulse Access Control Service Interoperability with the Junos Enforcer

http://www.juniper.net/techpubs/software/uac/4.2xguides/j-ic-uac-4.2-junosenforcers.pdf

Refer Section Before Configuring Captive Portal

 

Thanks

 

 

View solution in original post

1 REPLY 1
apaul_
Regular Contributor

Re: could not redirect https site enforcer config with nac-srx

Hello,

 

Captive portal only works on port 80 with HTTP.

Its documented in the Junos Pulse Access Control Service Interoperability with the Junos Enforcer

http://www.juniper.net/techpubs/software/uac/4.2xguides/j-ic-uac-4.2-junosenforcers.pdf

Refer Section Before Configuring Captive Portal

 

Thanks

 

 

View solution in original post