cancel
Showing results for 
Search instead for 
Did you mean: 

sftp load balancing

SOLVED
jlmickens
Occasional Contributor

sftp load balancing

I'm trying to set up load balancing on a pair of ServU ftp/sftp servers.  I used the wizard to do the FTP portion, but does anyone know how I can do the same for SFTP (as opposed to FTPS)?  SFTP uses port 22 (SSH).  I don't see either one of these options when trying to select a service for the virtual server.

1 ACCEPTED SOLUTION

Accepted Solutions
ldarby
Moderator

Re: sftp load balancing

Hi jlmickens,

 

As SFTP is just the SSH protocol then the protocol you need in vTM is Generic Server First.

 

Regards,

Laurence

Pulse Secure vADC Support (Acquired by Ivanti)

View solution in original post

4 REPLIES 4
ldarby
Moderator

Re: sftp load balancing

Hi jlmickens,

 

As SFTP is just the SSH protocol then the protocol you need in vTM is Generic Server First.

 

Regards,

Laurence

Pulse Secure vADC Support (Acquired by Ivanti)

View solution in original post

jlmickens
Occasional Contributor

Re: sftp load balancing

Thanks.  I'm new to managing the vTM.

jlmickens
Occasional Contributor

Re: sftp load balancing

After a bit, the pool is giving me errors.  I need to verify with the server team that it is functioning.

Node 72.240.104.29:22: Passive monitoring detected an error: Read error. Failed to read data from this node. First failed 105 seconds ago.  (This error was reported by PS-vTM02.buckeyecom.net)
Node 72.240.104.28:22: Passive monitoring detected an error: Read error. Failed to read data from this node. First failed 12 minutes ago, last tested 1 second ago.  (This error was reported by PS-vTM02.buckeyecom.net)
jlmickens
Occasional Contributor

Re: sftp load balancing

This was a destination server issue.