sftp load balancing

[jlmickens]

I'm trying to set up load balancing on a pair of ServU ftp/sftp servers.  I used the wizard to do the FTP portion, but does anyone know how I can do the same for SFTP (as opposed to FTPS)?  SFTP uses port 22 (SSH).  I don't see either one of these options when trying to select a service for the virtual server.

[ldarby · Accepted solution]

Hi jlmickens,

As SFTP is just the SSH protocol then the protocol you need in vTM is Generic Server First.

Regards,

Laurence

[jlmickens]

Thanks.  I'm new to managing the vTM.

[jlmickens]

After a bit, the pool is giving me errors.  I need to verify with the server team that it is functioning.

Node 72.240.104.29:22: Passive monitoring detected an error: Read error. Failed to read data from this node. First failed 105 seconds ago.  (This error was reported by PS-vTM02.buckeyecom.net)
Node 72.240.104.28:22: Passive monitoring detected an error: Read error. Failed to read data from this node. First failed 12 minutes ago, last tested 1 second ago.  (This error was reported by PS-vTM02.buckeyecom.net)

[jlmickens]

This was a destination server issue.