Hello Guys, I'm a complete newbie to Juniper devices, so I apologize in advance for any obvious answers to my questions. I've been tasked to configure an active/passive cluster with two Juniper SA6500 devices. One device is currently LIVE in service and the second device has been installed, licensed and configured with a IP's for the Management, Internal & External interfaces. From reading documentation, am I correct in saying that the cluster will use the internal interface to provide HA between both nodes? The bit I am stuck on is the VIP configuration, currently both devices have their internal interfaces configured on the same VLAN 683 (same range), do I need to assign VIP addresses within the same range (VLAN 683), if so where do I assign this address? I also assume that a VIP address needs to be created for the external access as well (VLAN 682), is this correct, if so where do I assign this address? Many Thanks, Regards Simon ... View more