Hi, There: Please help to review the steps of upgrading the cluster of A/P , the upgrading steps will be the following: 1. Upgrading the Passive node, and the clients will using the Active Node; 2. Passive Node reboot, and the active node detect the passive node in new version, hand over the client sessions to the passive nodes , and client session will be detected with the low version, were kicked off from the service. 3. Previous passive Node become the active node, and the active node will become the passive one and upgrading to the new version , also reboot. Please help to check if the steps are good and should the steps has "license issue". Also try to get the "release notes for 6.4.r2" , cannnot find . only one additional " Juniper Networks NetScreen Secure Access Release Notes " is found. Please advise Thanks for any comment. ... View more

Is this kind of VPN support the following scenario well: ( 6.4.0) ?  Wireless 11M, 3 more users using the SSL VPN service, each one could be assigned a fixed IP address ? When talking the support well, is the network connection will not break out accidental. And, in above case, what is the maximum number of users could be supported? Please advise. ... View more

Dear All: The Juniper SA6500 is interconnecting with the CISCO 3750, with 100M. There is quesition with the interface , which statistics shows:   MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,      reliability 255/255, txload 27/255, rxload 8/255   Encapsulation ARPA, loopback not set   Keepalive set (10 sec)   Full-duplex, 100Mb/s, media type is 10/100/1000BaseTX   input flow-control is off, output flow-control is unsupported   ARP type: ARPA, ARP Timeout 04:00:00   Last input never, output 00:00:00, output hang never   Last clearing of "show interface" counters 4d20h   Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 4169   Queueing strategy: fifo By checking the SA6500, there is no any drop packets. Please advise any possiblity of drops. Could expand the bandwidth of ethernet port from current 100M to 1000M would solve the problem? Thanks for any idea. ... View more