Products
Solutions
Partners
Support
Company
Try Now
Pulse Secure Community
Help
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
since ‎10-29-2017
‎10-29-2017
gnweber_
New Contributor

Re: SSG5 AutoKey IKE - Allows Connection, but no a...

by in Pulse Connect Secure
‎11-08-2009 06:04:AM
‎11-08-2009 06:04:AM
I found the following post in the Firewalls area this morning, which fixed my problem. The gist is to do the following: - Edit your VPN policy - Go in advanced configuration - Activate the source NAT with Egress Interface This works, but the contributor of the information says its a workaround and that the underlying issue may be a routing problem. In site-to-site configs I've seen static routes for routing the the tunnel. Is that required/possible in a dialaup VPN? Or should I be satisfied with the directions above and just leave well enough alone? I've attached my now working config... gnweber ... View more

SSG5 AutoKey IKE - Allows Connection, but no acces...

by in Pulse Connect Secure
‎11-07-2009 02:37:PM
‎11-07-2009 02:37:PM
I have an SSG5 setup with an AutoKey IKE VPN. I can connect to the VPN, ping the gateway (10.0.1.1) in the Trust zone, and even get to the WebUI for manangement of the SSG5 over the VPN. I can also ssh to the SSG5 while on the VPN connection. However, I cannot get to anything else in the Trust zone. Any help would be greatly appreciated. I have attached my config file for review. gnweber ... View more
Latest Tags
No tags yet
© 2017 Pulse Secure, LLC. Use of this website assumes acceptance of our Legal Notices and Privacy Policy. Pulse Secure has updated its Privacy Policy effective June 28, 2017.