Hi, We have tried to follow the instructions from this article-KB7994 and have not had any luck in getting it to work. Here is a breakdown of our network: 1. We have followed article KB4178 for connecting 2 NS5GT's and it's working fine. 2. Our local (hub) NS5GT has an internet GW address of 96.51.216.1 to the upstream ISP. The local subnet is 192.168.10.0/24 3. Our remote (spoke) NS5GT has an internet GW address of 75.159.160.1 to the upstream ISP. The local subnet is 192.168.9.0/24. 4. On the hub site, we have put in the following policy: 'set policy from trust to untrust 192.168.9.0/24 Any Any nat src permit' 5. We have setup on the remote (spoke) NS5GT under 'routing - destination' - 'set route 0.0.0.0/0 interface tunnel.1' Where do we put in the remaining static route in the remote (spoke) NS5GT to complete the routing to force traffic through the local (hub)? We have tried different variations and the internet traffic on the remote (spoke) is not going through the local (hub). It's still going out through the local ISP. Any suggestions? Thanks. Jason ... View more