I apologize if this isn't the correct forum or if my questions have already been answered. I am a front-end user (in a hotel/casino) and most of the terminology is outside of my scope. I am the hotel director. We utilize Microsoft Exchange. A few years ago we switched from using Terminal Services to access our network off property to Juniper Networks and myonelogin. I access our VPN through a browser. It goes to a myonelogin webpage where I enter my normal work username and password. It seems to me like myonelogin acts as portal through which my normal login becomes more secure than if I just tried to go straight to the VPN. I would like to be able to check guests in/out, assign rooms, check on room status, etc from our hotel lobby. We have a wireless network in the lobby; however, it is a dedicated DSL account just for guest use. Our primary network does not allow wireless access. In order to accomplish what I want, I will need to be able to login remotely. I am working on two solutions right now (tablet PC and iPad). The tablet PC is my second choice; however, I can do it with our existing configuration and my current knowledge. My IT department (property IT) just ordered a tablet for this solution because we can prove the usefulness of the capability. I need help with the iPad solution. It isnt a priority for my corporate IT team so they arent motivated to seek out the solution themselves. I want to show them the effectiveness (with the tablet results) and hand them a “map” so they can see how to make my iPad solution work. My problem is I don’t really know what to ask/tell our corporate IT team, neither does my property IT Director. I have installed Junos Pulse on my iPad. When I login on our VPN, login/password fails. When I access the VPN through the iPad, I am not going through the myonelogin site. URL through a PC: https://"company"vpn.myonelogin.com/SAAS/processSa mlBrowserProfile"dot"do URL on iPad: https://secure."company""dot"com Is it possible for me to gain access to our VPN via iPad utilizing Junos Pulse? If so, does a network administrator need to go into our Juniper configuration and make it so that Junos Pulse will work? Can you point me to some doccumentation that explains how to do this? Does myonelogin make it so Junos Pulse doesn’t work or add steps? Any suggestions as to what I should specifically ask for or relay to IT? Is there an alternate solution that I should be looking into? ... View more