- Pulse Secure Community
- :
- About Dilo_
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
since
10-29-2017
10-29-2017
Dilo_
Occasional Contributor
9
Posts
0
Kudos
0
Solutions
05-21-2013
05:33:AM
Switching the network policy from EAS to SSL did the trick. The issue ended up being the firewalls on the client devices not allowing EAS traffic through. Hence, the 60 second wait, then failback to SSL. Thanks for all the help!
... View more
05-17-2013
04:31:PM
Nothing is running with pulse on the dell. Although, Pulse auto start is disabled, have to open the program to initiate connection. Let me pull some logs.
... View more
05-17-2013
01:40:AM
Deployed 2 new windows 8 machines. 1 RT tablet and 1 standard Dell. When they both first connect to the pulse using the local client, they both immediately drop Internet connection. At least according to windows they do, although the pulse client does not disconnect. After about 60 seconds, the Internet comes back up and network access to both the Internet and the network on the pulse network works. I've tested in multiple locations and get the issue every single time. Any idea why this happens? Sounds like its a windows 8 networking problem, but just don't have enough knowledge on the subject.
... View more
03-15-2013
05:51:AM
Has anyone tried using a chromebook to connect to a Junos site and run something like a terminal session? I found an app that runs IE within the ChromeBook, but won't allow you to install the active-x plug-in, so its a no-go.
... View more
03-24-2012
03:54:PM
#1 did it - didn't have the proper group associated with it. Good catch - thanks Zany!
... View more
03-23-2012
12:20:PM
We have two terminal servers setup on our new MAG and we keep getting the following errror: The client could not connect to the remote computer. Remote connections might not be enabled or the computer might be too busy to accept new connections. It is also possible that network problems are preventing your connection. Multiple machines and browsers all come back with the same error. The MAG sits behind a Cisco ASA 5510 firewall. Is it a port issue on 3389 or a settings issue on the MAG?
... View more
Latest Tags
No tags yet
© 2017 Pulse Secure, LLC. Use of this website assumes acceptance of our Legal Notices and Privacy Policy.
Pulse Secure has updated its Privacy Policy effective June 28, 2017.
