About jro_

jro_ · ‎03-07-2014

hello all again, I inform you that even if I'm in a clean environment (without GPO), I'm still not authenticated after closing my user session. If anyone can help me. Regards, jro

jro_ · ‎03-05-2014

Hello everyone ! I'm on Junos Pulse Access Control Service, with the certificate authentication, and I have a question : when I start or restart my computer, the authentication (wired) works when starting the user session but when I close and open my user session the authentication doesn't work.. I have a message "authentication failed" and I have to disconnect and reconnect my thread to be able to connect properly. Therefore, it prevents my GPO work, so I can not install a msi that runs logon (because not authenticated logon). Do you know where my problem may come, of my UAC or my GPO configuration ? Thank you in advance for your response. jro

jro_ · ‎03-05-2014

Yes :) Thank you ! jro

jro_ · ‎01-31-2014

Hello everyone ! I'm new to this forum and I am currently training to implement an authentication service with Juniper UAC. I'm on Junos Pulse Access Control Service and I have a question : how to assign a VLAN according to the AD group of a user? My RADIUS client is a Cisco Catalyst 2950 and my AD server is already set up and connected to my UAC. Thank you in advance for your response. jro P.S : sorry if I have not posted in the right forum ...

Re: Unauthenticated when the session opens

Unauthenticated when the session opens

Re: VLAN based on AD group

VLAN based on AD group